PERFORMANCE GUIDE
|
FILM PROPERTIES
Chemical Resistance
Heat Resistance
Water Resistance
|
Excellent against splashes and spillage of common acids, alkalis, solvents, and salt solutions.
Can be used on heated surfaces up to 110°C.
Excellent.
|
THEORECTICAL COVERAGE
|
A guide to the theoretical coverage which can be achieved under normal conditions is 10.5 - 21 m²/L.
|
PRODUCT DATA
|
COMPOSITION
(nominal)
|
Pigment : Lightfast Non-Lead Pigments and Inert Mineral Extenders.
Blinder : Polyamide Cured Epoxy.
Solvent : Aromatic Hydrocarbons and Alcohol.
|
VOLUME SOLIDS
|
63% (nominal).
|
FLASH POINT
|
Base and Activator - 22°C.
|
POT LIFE
|
Up to 7 hours at 30°C.
|
APPLICATION
|
MIXING RATIO
|
7 parts Base to 1 part Activator by volume.
|
THINNING
Brush or Roller
Conventional Spray
Airless Spray
|
Ready for use. Thinning is not usually necessary
Add up to 1 part of Dulux Thinner 850 - 11 to 5 parts of paint (20%).
Add up to 1 part of Dulux Thinner 850 - 11 to 20 parts of paint (5%).
|
SPRAY RECOMMENDATIONS
Conventional Spray
Airless Spray
|
Satisfactory through most equipment.
A typical set up for airless spray application is a minimum working pressure on paint of 140kg/cm² (2000 lb/sq in) with a spray tip size 0.43 - 0.53mm (17-21 thou) and a spray tip angle of 20° - 45°.
|
SPRAY NOTES
|
It is important that the Base and the Activator are at the minimum temperature of 15°C when mixed for satisfactory spray application.
|
CURING TIMES
Recoat At 30°C
Full Cure
|
Single coat at standard thickness:
6 hours minimum, up to 14 days maximum.
7 days.
Please note that the reaction of epoxies commences immediately after the two components are mixed. This reaction is temperature related and so the curing time will be approximately halved by a 10°C increase in temperature and doubled by a 10°C decrease in temperature.
|
CLEANING UP
|
Clean all equipment with Dulux Thinner 850 - 11 immediately after use.
|
FILM THICKNESS
|
Wet: 50 - 95 micro-metres
Dry: 30 - 60 micro-metres.
|
|
   
|
PRE - APPLICATION
|
SURFACE PREPARATION
|
Surfaces must be clean, dry, free from all adhering material, dirt, grease, wax etc. Degrease where necessary with a suitable Oil and Grease Remover. Rinse with clean water to remove residues.
|
SYSTEM INFORMATION
Metal
|
PRIMER (1 COAT)
Dulux Epoxy Primer Off White (A580 - PJ - 0529)
|
UNDERCOAT
N/A
|
FINISH (2 COATS)
Dulux Epoxy Chemical Resistant Finish (A430)
Or
Dulux Chlorinated Rubber Finish (A404)
|
|
|
It is important to ensure that the substrate temperature is at least 3°C above dew point.
The minimum temperature for application is 10°C. Relative humidity should not exceed 85%.
Note: Where the Dulux Epoxy Primer Off White has been left exposed over a period of time, it will be necessary to thoroughly prepare the surface all dirt, grease, oil, wax, salts etc before the overpainting.
|
|
 
|
PRECAUTION
|
SAFETY, HEALTHY AND ENVIRONMENTAL INFORMATION
|
FLAMMABLE
Toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
Contains Epoxy constituents. See information provided by the manufacturer.
Harmful by inhalation and in contact with skin.
Irritating to eyes and skin. May cause sensitisation by skin contact.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
If swallowed seek medical advice immediately and show this container or label.
If swallowed, rinse mouth with water (Only if person is conscious).
Keep away from food, drinks, animal feed and out of the reach of children.
Keep away from combustible material.
Container must be stored in a cool and shaded place.
It must be tightly closed in a secure, upright position. Do not breathe dust.
Work in a well-ventilated area and do not breathe in vapour or spray.
When applying paint, wear suitable protective clothing, gloves and eye/face protection.
In case of fire use foam, dry powder, AFFF, CO2 - Never use water.
In case of a spillage, contain and collect spillage using sand or earth and do not empty into watercourses, drains or the environment.
Dispose of any paint waste in accordance with the appropriate Environmental Quality Regulations.
Refer to Dulux Product Safety Data Sheet for further details.
In case of emergency, refer to Emergency Incident Response Hotline 1800 80 6187.
|
|
      
|
