PERFORMANCE GUIDE
|
FILM PROPERTIES
Water Resistance
|
Will tolerate the levels of atmospheric humidity present in exterior environments.
|
THEORECTICAL COVERAGE
|
A guide to the theoretical coverage which can be achieved under normal conditions is 15 m²/5 litre.
|
PRODUCT DATA
|
COMPOSITION
(nominal)
|
Pigment : Lightfast Non-Lead Pigments and Mineral Extenders.
Blinder : Acrylic Emulsion.
Solvent : Water..
|
VOLUME SOLIDS
|
50% (nominal), some colours will vary.
|
APPLICATION
|
THINNING
Brush or Roller
Conventional Spray
Airless Spray
|
On cool tiles, add up to 1 part of clean water to 10 parts of paint (10%).
On hot tiles, add up 1 part of clean water to 5 parts of paint (20%).
Add up to 1 part of clean water to 5 parts of paint (50%).
Ready for use.
|
SPRAY RECOMMENDATIONS
Conventional Spray
Airless Spray
|
Satisfactory through most equipment.
A typical set up for airless spray application would be a minimum working pressure on paint of 140Kg/cm² (2000 lb/sq in) with a spray tip size 0.58mm (23 thou) and a spray tip angle 65°
|
DRYING TIMES
Touch Dry
Recoat
|
Single coat at standard thickness:
1 hour.
2 - 3 hours.
|
CLEANING UP
|
Clean all equipment with clean water immediately after use.
|
|
   
|
PRE - APPLICATION
|
SURFACE PREPARATION
|
Surfaces to be painted must be clean to ensure good adhesion. Remove all loose or defective paint or powdery residues by thorough brushing or scraping, using a stiff fibre brush with running water or high pressure water jet. Treat any areas affected by mould, lichens, algae, and moss with Dulux Fungicidal Wash. Make good minor cracks with Selleys No More Gaps. Use a sand and cement mix for larger holes and cracks. Allow to dry before priming with Dulux Roofshield Adhesion Primer.
Note: Paint will not adhere on dirty and powdery substrates which are not thoroughly cleaned. Do not apply Roofshield during wet weather.
|
SYSTEM INFORMATION
Clean Weathered Roof Tiles
|
PRIMER (1 COAT)
Dulux Roofshield Primer
(A579 - 10611)
|
FINISH (2 COATS)
Dulux Roofshield
(A968)
|
|
|
   
|
PRECAUTION
|
SAFETY, HEALTHY AND ENVIRONMENTAL INFORMATION
|
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice
To remove splashes of paint from skin, use soap and water or a recognised cleanser.
Keep away from food, drinks, animal feed and out of the reach of children.
Container must be stored in a cool and shaded place
It must be tightly closed in a secure, upright position
Work in a well-ventilated area and do not breathe in vapour or spray
A suitable mask should be worn during sanding
When applying paint, it is advisable to wear eye protection and suitable gloves
In case of a spillage, contain and collect spillage using sand or earth and do not empty into water courses, drains or the environment
Dispose of any paint waste in accordance with the appropriate Environmental Quality Regulations
Refer to Dulux Product Safety Data Sheet for further details
In case of emergency, refer to Emergency Incident Response Hotline 1800 80 6187.
|
|
     
|
