PERFORMANCE GUIDE
|
FILM PROPERTIES
Water Resistance
|
Resistant to mild atmospheric fume attack and to the salts in new mortar, rendering and similar surfaces.
Resistant to the levels of atmospheric humidity present in normal exterior environments.
|
THEORECTICAL COVERAGE
|
The spreading capacity of this product will vary considerably according to the roughness and porosity of the surface. On smooth surfaces of average porosity 10m²/L.
|
PRODUCT DATA
|
COMPOSITION
(nominal)
|
Pigment : Lightfast Non-Lead Pigments and Mineral Extenders.
Blinder : Acrylic Emulsion.
Solvent : Water.
|
VOLUME SOLIDS
|
White 35% (nominal), other colours will vary
|
APPLICATION
|
THINNING
Brush or Roller
|
For sealing new or bare surfaces thin with up to 1 part of clean water to 10 parts of paint (10%).
For normal use thinning is usually not required.
|
DRYING TIMES
Touch Dry
Recoat
|
Single coat at standard thickness:
Dependant on temperature and humidity.
2 - 3 hours.
|
CLEANING UP
|
Clean all equipment with clean water immediately after use.
|
|
  
|
PRE - APPLICATION
|
|
SURFACE PREPARATION
|
Allow all new surfaces to dry out completely. Remove all loose or defective paint or powdery residues by thorough brushing and scraping, using a stiff fibre brush or high pressure water jet. Treat any areas affected by mould, lichens, algae and moss with Dulux Fungicidal Wash. Make good munor defects with a suitable exterior grade Filler. Use a sand and cement mix for larger holes and cracks. Allow to dry. Surfaces that remain powdery, friable or chalky after thorough preparation should be sealed with a coat of Dulux Adhesion Promoting Wall Sealer.
|
|
Note: Do not apply Glidden Duraguard Acrylic Exterior Finish during wet weather.
|
SYSTEM INFORMATION
Powdery Surfaces
Alkaline and New Surfaces
Normal, Sound Surfaces
|
PRIMER (1 COAT)
Dulux Weathershield Primer (A579 - 15222)
Dulux Weathershield Sealer (A931 - 18177)
A thinned first coat Glidden Duraguard Acrylic Exterior Finish (A920)
|
FINISH (2 COATS)
Glidden Duraguard Acrylic Exterior Finish (A920)
|
|
|
   
|
PRECAUTION
|
SAFETY, HEALTHY AND ENVIRONMENTAL INFORMATION
|
Harmful to aquatic organisms, may cause long-term adverse effects in the aquatic environment.
May cause sensitisation by skin contact.
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
To remove splashes of paint from skin, use soap and water or a recognised cleanser.
Keep away from food, drinks, animal feed and out of the reach of children.
Container must be stored in a cool and shaded place.
It must be tightly closed in a secure, upright position.
Work in a well-ventilated area and do not breathe in vapour or spray.
A suitable mask should be worn during sanding.
When applying paint, it is advisable to wear eye protection and suitable gloves.
In case of a spillage, contain and collect spillage using sand or earth and do not empty into watercourses, drains or the environment.
Dispose of any paint waste in accordance with the appropriate Environmental Quality Regulations.
Refer to Glidden Product Safety Data Sheet for further details.
In case of emergency, refer to Emergency Incident Response Hotline 1800 80 6187.
|
|
     
|
