PERFORMANCE GUIDE
|
FILM PROPERTIES
Water Resistance
|
Will tolerate a slightly damp surface but is not suitable where the surface is saturated.
|
THEORECTICAL COVERAGE
|
A guide to the theoretical coverage which can be achieved under normal conditions is 11 m²/litre.
|
PRODUCT DATA
|
COMPOSITION
(nominal)
|
Pigment : Lightfast Non-Lead Pigments and Mineral Extenders.
Blinder : Acrylic Emulsion.
Solvent : Water. |
VOLUME SOLIDS
|
White 33% (nominal)
|
APPLICATION
|
THINNING
Brush or Roller
Conventional Spray
Airless Spray
|
For sealing new or bare surfaces thin with up to 1 part of clean water to 10 parts of paint (10%).
For normal use thinning is usually not required.
Add up to 1 part clean water to 10 parts of paint (10%).
Ready for use.
|
SPRAY RECOMMENDATIONS
Conventional Spray
Airless Spray
|
Satisfactory through most equipment.
A typical set up for airless spray application would be a minimum working pressure on paint of 140 kg/cm² (2000 lb/sq in) with a spray tip size 0.38mm (15 thou) and a spray tip angle 65°.
|
DRYING TIMES
Touch Dry
Recoat
|
Single coat at standard thickness:
Dependant on temperature and humidity.
2 - 3 hours.
|
CLEANING UP
|
Clean all equipment with clean water immediately after use.
|
|
   
|
PRE - APPLICATION
|
|
SURFACE PREPARATION |
Surfaces must be sound, clean, as dry as possible and free from all defective or poorly adhering material, dirt, grease, wax.
If after thorough preparation surfaces remain powdery, or suffer from alkali attack seal with one coat of an appropriate Primer (see below).
Note: Even though this primer facilitates painting on damp wall, it should not be applied on areas where moisture reading (as measured by protimeter) exceeds 22%. These walls should be left to dry further. However, if painted, the moisture will build up behind this waterproof primer and cause blisters to emerge on the paint film on aging.
|
SYSTEM INFORMATION
Powdery Surfaces
Alkaline and New Surfaces
Normal, Sound Surfaces
|
PRIMER (1 COAT)
Dulux Adhesion Promoting Wall Sealer (A579-15222)
Glidden Wall Sealer 368 (A931-15368)
No Primer Required.
|
UNDERCOAT (1 COAT)
N/A
N/A
Dulux Speed Undercoat (A545-101) |
FINISH (2 COATS)
Glidden Satin Silk (A929)
Glidden Hi-Gloss (A336)
|
|
|
  
|
PRECAUTION
|
SAFETY, HEALTHY AND ENVIRONMENTAL INFORMATION
|
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
To remove splashes of paint from skin, use soap and water or a recognised cleanser.
Keep away from food, drinks, animal feed and out of the reach of children.
Container must be stored in a cool and shaded place.
It must be tightly closed in a secure, upright position.
Work in a well-ventilated area and do not breathe in vapour or spray.
A suitable mask should be worn during sanding.
When applying paint, it is advisable to wear eye protection.
In case of a spillage, contain and collect spillage using sand or earth and do not empty into watercourses, drains or the environment.
Dispose of any paint waste in accordance with the appropriate Environmental Quality Regulations.
Refer to Glidden Product Safety Data Sheet for further details.
In case of emergency, refer to Emergency Incident Response Hotline 1800 88 9338. |
|
 
|
