PERFORMANCE GUIDE
|
FILM PROPERTIES
Chemical Resistance
Water Resistance
|
Not suitable
Will tolerate the levels of atmospheric humidity present in normal interior environments and will withstand moderately vigorous washing. Also suitable where frequent heavy condensation is likely, as in kitchens and bathrooms.
|
THEORECTICAL COVERAGE
|
The spreading capacity of this product will vary considerable according to the roughness and porosity of the surface. On smooth surfaces of average porosity 11 - 12 m²/litre.
|
|
PRODUCT DATA
|
COMPOSITION
(nominal)
|
Pigment : Lightfast Non-Lead Pigments and Mineral Extenders.
Blinder : Acrylic Copolymer Emulsion.
Solvent : Water.
|
VOLUME SOLIDS
|
White 37% (nominal), other colours will vary
|
|
APPLICATION
|
THINNING
Brush or Roller
Conventional Spray
Airless Spray
|
For sealing new or bare surfaces thin with up to 1 part of clean water to 5 parts of paint (20%). For normal use, thinning is usually not necessary. If required, should not exceed 1 part of clean water to 10 parts of paint (10%).
Add up to 1 part of clean water to 5 parts of paint (20%).
Ready for use.
|
SPRAY RECOMMENDATIONS
Conventional Spray
Airless Spray
|
Satisfactory through most equipment.
A typical set up for airless spray application would be a minimum working pressure on paint of 140Kg/cm² (2000 lb/sq in) with a spray tip size 0.38mm (15 thou) and a spray tip angle 65°.
|
DRYING TIMES
Touch Dry
Recoat
|
Single coat at standard thickness:
Dependant on temperature and humidity.
1 - 2 hours.
|
CLEANING UP
|
Clean all equipment with clean water immediately after use.
|
|
PRE - APPLICATION
|
SURFACE PREPARATION
|
Surfaces must be sound, clean, dry and free from all defective or poorly adhering material, dirt, grease or wax and be thoroughly rubbed down using a suitable abrasive paper and dusted off. If after thorough preparation, surfaces remain powdery, seal with one coat of an appropriate Primer (see below).
|
SYSTEM INFORMATION
Powdery Surfaces
Alkaline and New Surfaces
Normal, Sound Surfaces
|
PRIMER (1 COAT)
Dulux Adhesion Promoting
Wall Primer (A579 - 15458)
Dulux Alkali Resisting
Wall Sealer (A931 - 18380)
No Primer Required.
|
FINISH (2 COATS)
Dulux Sterishield Satin Finish (A933)
|
|
|
PRECAUTION
|
SAFETY, HEALTHY AND ENVIRONMENTAL INFORMATION
|
In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
To remove splashes of paint from skin, use soap and water or a recognised cleanser.
Keep away from food, drinks, animal feed and out of the reach of children.
Container must be stored in a cool and shaded place.
It must be tightly closed in a secure, upright position.
Work in a well-ventilated area and do not breathe in vapour or spray.
A suitable mask should be worn during sanding.
When applying paint, it is advisable to wear eye protection and suitable gloves. In case of a spillage, contain and collect spillage using sand or earth and do not empty into watercourses, drains or the environment.
Dispose of any paint waste in accordance with the appropriate Environmental Quality Regulations.
Refer to Dulux Product Safety Data Sheet for further details.
In case of emergency, refer to Emergency Incident Response Hotline 1800 80 6187.
|
|
     
|
